Table of Contents
Advertisement
Battery Safety Information
Effective April 1, 2016, IATA regulations (UN 3480, PI 965) require that air-shipped lithium ion
batteries must be transported at a state of charge not exceeding 30%. To avoid total discharge,
fully charge the battery immediately upon receipt.
NOTE: If the battery was not sent by air, it may be fully-charged.
Safety Precautions
Store batteries upright at:
l
Never expose the battery to water. If the battery is leaking, submerge in mineral oil and
l
contact your local Omron Support.
In case of fire, use a type D extinguisher: foam, dry chemical, or CO
l
Maintenance
Every six months:
Inspect battery for damage or leaks.
l
Place battery on a charger and allow to fully balance (battery shows all solid LEDs
l
when fully balanced).
Overview
In general, setup is the physical and logical preparation of the platform, configuration of the
wireless network, and the installation of the docking station. The physical preparation of the
platform includes attaching your payload structure to the platform.
Setup also includes generating the map the platform will use for navigation. This manual
provides an overview of that process, which is covered in detail in the Mobile Robot Software
Suite User's Guide.
11970-000 Rev H1
CAUTION: Possible battery damage. Immediately charge the battery to a full
charge after receipt to avoid the risk of discharging the battery below a usable
state, which would require battery replacement.
One month: +5 to 45°C (41 to 113°F)
n
One year: 20 to 25°C (68 to 77°F)
n
LD Platform OEM User's Guide
Chapter 3: Setup
.
2
25
Advertisement
Table of Contents
