Maintaining And Replacing Batteries; Maintaining Batteries; Replacing The Battery - Omron LD Platform User Manual

8.5 Maintaining and Replacing Batteries
Docking Station Contacts
The two docking station contacts need occasional cleaning. The suggested interval is 3 – 6
months, depending on frequency of charging.
Clean the contacts with Isopropyl alcohol.

8.5 Maintaining and Replacing Batteries

Maintaining Batteries

Every six months, inspect batteries (both stored and in-use) for damage or leaks.
l
If a battery is found to be leaking, do not expose it to water. If possible, submerge it in
mineral oil.
Contact your local Omron Support immediately for disposal instructions.
Store batteries upright at (one month) +5 to 45°C (41 to 113°F); (one year) 20 to 25°C (68
l
to 77°F).
Every six months, charge stored batteries to a full charge.
l

Replacing the Battery

The battery is expected to last for approximately ≥ 2000 recharge cycles.
NOTE: There are no user-serviceable parts inside the battery case. Do not open it.
Dispose of the battery according to all local and national environmental regulations regarding
electronic components.
106
WARNING: Unplug power from the docking station before starting. Remove
the charger's power cord.
CAUTION: Do not lubricate the docking station paddle, which will reduce its
life.
WARNING: Replace the battery only with a Omron Adept Technologies, Inc.
factory-supplied battery.
WARNING: Follow appropriate ESD procedures during the
removal/replacement phases.
LD Platform OEM User's Guide 11970-000 Rev H1