Figure 3.47 Configuration > Automatic Update - Advantech WISE-6610 Series User Manual

To access this page, click Configuration > Automatic Update.
Item
Base URL
Unit ID
Update Hour
The configuration file name consists of Base URL, hardware MAC address of ETH0
interface and cfg extension. Hardware MAC address and cfg extension are added to
the file name automatically and it isn't necessary to enter them. When the parameter
Unit ID is enabled, it defines the concrete configuration name which will be
downloaded to the device, and the hardware MAC address in the configuration name
will not be used.
The firmware file name consists of Base URL, type of device and bin extension. For
the proper firmware filename, see the Update Firmware page in Administration
section - it us written out there. See "Update Firmware" on page 66.
Note! It is necessary to load two files (.bin and .ver) to the HTTP/FTP server. If
only the .bin file is uploaded and the HTTP server sends the incorrect
answer of 200 OK (instead of the expected 404 Not Found) when the
device tries to download the nonexistent .ver file, then there is a risk that
the device will download the .bin file over and over again.
Note! Firmware update can cause incompatibility with the user modules. It is
recommended that you update user modules to the most recent version.
Information about the user modules and the firmware compatibility is at
the beginning of the user module's Application Note.
WISE-6610 Series User Manual
Figure 3.47 Configuration > Automatic Update
Description
Base URL, IPv4 or IPv6 address from which the configuration file will
be downloaded. This option also specifies the communication protocol
(HTTP, HTTPS, FTP or FTPS), see examples below.
Name of configuration (name of the file without extension). If the Unit
ID is not filled, the MAC address of the device is used as the filename
(the delimiter colon is used instead of a dot.)
Use this item to set the hour (range 1-24) when the automatic update
will be performed every day. If the time is not specified, automatic
update is performed five minutes after turning on the device and then
every 24 hours. If the detected configuration file is different from the
running one, it is downloaded and the device is restarted
automatically.
55