Advantech WISE-6610 Series User Manual page 33

Item
Default Gateway
DNS Server
The Default Gateway and DNS Server items are only used if the DHCP Client item is
set to disabled and if the Primary or Secondary LAN is selected by the Backup
Routes system as the default route. Since FW 5.3.0, Default Gateway and DNS
Server are also supported on bridged interfaces.
The following items (in the table below) are global for the configured Ethernet
interface. Only one bridge can be active on the device at a time. The DHCP Client, IP
Address and Subnet Mask / Prefix parameters of the only one of the interfaces are
used to for the bridge. Primary LAN has higher priority when other interfaces (wlan0)
are added to the bridge. Other interfaces (wlan0 - wifi) can be added to or deleted
from an existing bridge at any time. The bridge can be created on demand for such
interfaces, but not if it is configured by their respective parameters.
Item
Bridged
Media Type
3.4.1.1 DHCP Server
The DHCP server assigns the IP address, gateway IP address (IP address of the
device) and IP address of the DNS server (IP address of the device) to the connected
clients. If these values are filled in by the user in the configuration form, they will be
preferred.
The DHCP server supports static and dynamic assignment of IP addresses. Dynamic
DHCP assigns clients IP addresses from a defined address space. Static DHCP
assigns IP addresses that correspond to the MAC addresses of connected clients.
If IPv6 column is filled in, the DHCPv6 server is used - it is dual stack IPv4 and IPv6.
Note! Do not to overlap ranges of static allocated IP addresses with addresses
allocated by the dynamic DHCP server. IP address conflicts and
incorrect network function can occur if you overlap the ranges.
Description
Specifies the IP address of a default gateway. If filled-in, every packet
with the destination not found in the routing table is sent to this IP
address. Use proper IP address notation in IPv4 and IPv6 column.
Specifies the IP address of the DNS server. When the IP address is
not found in the Routing Table, the device forwards the request to
DNS server specified here. Use proper IP address notation in IPv4
and IPv6 column.
Description
Activates/deactivates the bridging function on the device.

no - The bridging function is inactive (default).

yes - The bridging function is active.
Specifies the type of duplex and speed used in the network.

Auto-negation - The device automatically sets the best speed
and duplex mode of communication according to the network's
possibilities.

100 Mbps Full Duplex - The device communicates at 100 Mbps,
in the full duplex mode.

100 Mbps Half Duplex - The device communicates at 100 Mbps,
in the half duplex mode.

10 Mbps Full Duplex - The device communicates at 10 Mbps, in
the full duplex mode.

10 Mbps Half Duplex - The device communicates at 10 Mbps, in
the half duplex mode.
22 WISE-6610 Series User Manual