Advantech WISE-6610 Series User Manual page 44

Item
Protocol
UDP Port
Remote IP Address
Remote Subnet
Remote Subnet
Mask
Redirect Gateway
Local Interface IP
Address
Remote Interface IP
Address
Remote IPv6 Subnet Specify the subnet associated with the listed remote interface.
Remote IPv6 Subnet
Prefix Length
Local Interface IPv6
Address
Remote Interface
IPv6 Address
Ping Interval
Ping Timeout
Renegotiate Interval Specifies the renegotiate period (reauthorization) of the OpenVPN
Max Fragment Size
Compression
NAT Rules
WISE-6610 Series User Manual
Description
Specifies the communication protocol.

UDP - The OpenVPN communicates using UDP.

TCP server - The OpenVPN communicates using TCP in server
mode.

TCP client - The OpenVPN communicates using TCP in client
mode.

UDPv6 - The OpenVPN communicates using UDP over IPv6.

TCPv6 server - The OpenVPN communicates using TCP over
IPv6 in server mode.

TCPv6 client - The OpenVPN communicates using TCP over
IPv6 in client mode.
Specifies the port of the relevant protocol (UDP or TCP).
Specifies the IPv4, IPv6 address or domain name of the opposite side
of the tunnel.
IPv4 address of a network behind opposite side of the tunnel.
IPv4 subnet mask of a network behind opposite tunnel's side.
Activates/deactivates redirection of data on Layer 2.
Specifies the IPv4 address of a local interface. For proper routing it is
recommended to fill-in any IPv4 address from local range even if you
are using IPv6 tunnel only.
Specifies the IPv4 address of the interface of opposite side of the
tunnel. For proper routing it is recommended to fill-in any IPv4
address from local range even if you are using IPv6 tunnel only.
IPv6 address and prefix of the remote IPv6 network. Equivalent of the
Remote Subnet and Remote Subnet Mask in IPv4 section.
Specifies the IPv6 address of a local interface.
Specifies the IPv6 address of the interface of opposite side of the
tunnel.
Specifies the IPv6 address of the interface of opposite side of the
tunnel.
Specifies the time interval the device waits for a message sent by the
opposite side. For proper verification of the OpenVPN tunnel, set the
Ping Timeout to greater than the Ping Interval.
tunnel. You can only set this parameter when the Authenticate Mode
is set to username/password or X.509 certificate. After this time
period, the device changes the tunnel encryption to help provide the
continues safety of the tunnel.
Maximum size of a sent packet.
Compression of the data sent:

none - No compression is used.

LZO - A lossless compression is used, use the same setting on
both sides of the tunnel.
Activates/deactivates the NAT rules for the OpenVPN tunnel:

not applied - NAT rules are not applied to the tunnel.

applied - NAT rules are applied to the OpenVPN tunnel.
33