Automatic Update; Figure 3.46 Example Of Ipv6 Up/Down Script - Advantech WISE-6610 Series User Manual

Example: IPv6 Up/Down Script
After establishing or losing an IPv6 WAN connection (connection to mobile network),
the device sends an email with information about the connection state. It is
necessary to configure SMTP before.
Add this line to the Up Script field:
email -t name@domain.com -s "Router" -m "Connection up."
Add this line to the Down Script field:
email -t name@domain.com -s "Router" -m "Connection down."
3.4.10

Automatic Update

Use the Automatic Update menu to configure the automatic update settings. The
device can be configured to automatically check for firmware and configuration
updates from a HTTP(S) or FTP(S) server. IPv6 sites/servers are supported. Used
protocol is specified by an address in Base URL field: HTTP, HTTPS, FTP or FTPS.
To prevent possible unwanted manipulation of the files, the device verifies that the
downloaded file is in the tar.gz format. At first, the format of the downloaded file is
checked. Then the type of architecture and each file in the archive (tar.gz file) is
checked.
If the Enable automatic update of configuration option is selected, the device will
check if there is a configuration file on the remote server, and if the configuration in
the file is different than its current configuration, it will update its configuration to the
new settings and reboot.
If the Enable automatic update of firmware option is checked, the device will look for
a new firmware file and update its firmware if necessary.

Figure 3.46 Example of IPv6 Up/Down Script

54 WISE-6610 Series User Manual