2.4
Connecting the Gateway to Ethernet Port
2.4.1
RJ45 Ethernet Cable Wiring
For RJ45 connectors, data-quality, twisted pair cabling (rated CAT5 or better) is rec-
ommended. The connector bodies on the RJ45 Ethernet ports are metallic and con-
nected to the GND terminal. For best performance, use shielded cabling. Shielded
cabling may be used to provide further protection.
Straight-thru Cable Wiring
Pin 1
Pin 2
Pin 3
Pin 6
Maximum cable length: 100 meters (328 ft.) for 10/100BaseT.
2.5
Power Supply Installation
1.
Insert the power cable into the power socket. The cable locks in place if installed
correctly.
2.
Connect the other end to a wall outlet.
The LEDs light when the device is connected to the power source
The following table show the color lines definition:
V+
Red
Cross-over Cable Wiring
Pin 1
Pin 1
Pin 2
Pin 2
Pin 3
Pin 3
Pin 6
Pin 6
Figure 2.8 Ethernet Plug & Connector Pin Position
Figure 2.9 Installing the Power Cable
DI
GND
Yellow
Black
Pin 3
Pin 6
Pin 1
Pin 2
8
1
R a
L o
I / O
N
W A
H
T
E T
D A
R
P W
D0
Gray
12
WISE-6610 Series User Manual