Figure 3-7 Bridge Page - Zte ZXHN H267N Management Manual

5. Set the parameter Type to be Bridge connection. The Bridge-based connection
page is displayed,

Figure 3-7 Bridge Page

Table 3-4
Table 3-4 Parameter Descriptions for the Bridge-based connection
Parameter
Connection Name
xDSL Transfer Mode
ATM Parameters
VPI/VCI
Service Type
PCR
SJ-20140702105807-002|2014-11-13 (R1.0)
seeFigure 3-7.
lists the New Item parameters.
Chapter 3 Configure the Internet
Description
Name the connection.
There are two xDSL transfer modes:
l ATM
l PTM
In the case of IPv4_PPPoE, select PTM.
If xDSL Transfer ModeEnter is selected to be ATM,
the VPI/VCI values provided by the ISP needs to be
configured.
VPI Range: 0 - 255.
VCI Range: 0 - 65535.
If xDSL Transfer ModeEnter is selected to be ATM,
Service Type needs to be configured.
ATM QoS used to limit the transmission of uplink traffic.
The options are: CBR, RT-VBR, nRT-VBR, and UBR.
If Service Type is selected to be CBR,RT-VBR or
nRT-VBR, PCR needs to be configured.
3-11
ZTE Proprietary and Confidential