Figure 3-4 Bridge Page - Zte ZXHN H267N Management Manual

ZXHN H267N Maintenance Management Guide

Figure 3-4 Bridge Page

Table 3-2
Table 3-2 Parameter Descriptions for the Bridge Mode
Parameter
Connection Name
Type
Service List
VLAN Switch
VLAN ID
6. Click Apply.
l
Modify a WAN connection.
Select an existing WAN connection from the Connection Name list and modify
the parameters. After the parameters are set as required, click Apply.
l
Delete a WAN connection.
Select an existing WAN connection from the Connection Name list and click
l
WAN connection modification and deletion may cause service failure. Perform
the modification and deletion operations with care.
SJ-20140702105807-002|2014-11-13 (R1.0)
lists the New Item parameters.
Description
To create a WAN connection, select Create WAN Connection.
To query or modify an existing WAN connection, select the corresponding
WAN connection.
The connection type includes Route and Bridge Connection.
In this case, Bridge is selected.
INTERNET is selected. It indicates that the WAN connection supports the
Internet access service only.
Valid only if the VLAN switch feature is enabled.
If theVLAN
Range: 1–4094. To ensure normal service operation, the VLAN ID must be
the same as that set in upper-layer OLT configuration.
Note:
function is enabled, VLAN ID is needed to be configured.
3-6
ZTE Proprietary and Confidential
.