Zte ZXHN H267N Management Manual page 20

ZXHN H267N Maintenance Management Guide
Table 3-1 Parameter Descriptions for the Route Mode
Parameter
Connection Name
Type
Service List
MTU
Link Type
PPP TransType
PPP
Username
Password
IP Version
IPv6
IPv6 Info Get
Mode
SJ-20140702105807-002|2014-11-13 (R1.0)
Description
To create a WAN connection, select Create WAN Connection.
To query or modify an existing
WAN connection.
The connection type includes route and bridge connection.
In this case, route is selected.
Options: INTERNET, TR069, INTERNET_TR069_, VoIP, INTERNET_VoIP,
VoIP_TR069, INTERNET_VoIP_TR069, and OTHER.
This parameter must be consistent with service configuration. For example,
if INTERNET is selected, it indicates that the WAN connection supports the
Internet access service only. If TR069 is selected, it indicates that the WAN
connection supports remote management. If VoIP is selected, it indicates
that the WAN connection supports the voice service.
Maximum Transfer Unit (MTU) of the WAN connection. Range: 128–1492,
default: 1492.
There are two link types:
l PPP
l IP
The default value is PPPoE.
Username of the PPPoE account. The username must be the same as that
set on the peer server for authentication.
Password of the PPPoE account. The Password must be the same as that
set on the peer server for authentication.
IP version that the device supports. Normally, it is set to IPv4/IPv6.
l
IPv4: The device supports
l
IPv6: The device supports
l
IPv4/IPv6: The device supports both
Specifies how to acquire
only if the WAN connection supports IPv6.
l Manual Mode: You need to set the global address, gateway, and
acquisition modes.
l
Auto Mode: The global address, gateway, and
are automatically configured.
l
IPv6CP Extension Mode: The IPv6CP extension mode is used.
3-4
WAN connection, select the corresponding
IPv4 addresses only.
IPv6 addresses only.
IPv4 and
IPv6 information for the WAN connection. It is valid
ZTE Proprietary and Confidential
IPv6 addresses.
DNS
DNS acquisition modes