Configure The Ddns - Zte ZXHN H267N Management Manual

Parameter
Service Type
Trigger Port
Connect Type
WAN
Timeout
3. Click Apply button to apply the changes.
– End of Steps –

3.5 Configure the DDNS

The section describes how to configure DDNS. DDNS provides the parameters of
configuration function.
Steps
1. On the main page of the ZXHN H267N, select Internet > DDNS to go to the DDNS
page, the page as shown in
SJ-20140702105807-002|2014-11-13 (R1.0)
Port Range
Description
The service type of the application, including TCP, UDP,
and TCP AND UDP.
The default service type is TCP.
The port that the application uses.
The connection type that is used to connect the outside,
including TCP, UDP, and
The default service type is TCP.
Specify the port range of the device protocol that the
triggering port maps, that is, the layer-4 port number of
the packets.
Once the device accesses the triggering port, the service
between the start port and end port will be enabled.
The WAN Start Port and
and meet the following conditions.
l The end port number is larger than the start port
number.
l
The difference between the end port number and the
start port number is less than nine.
The time when no traffic occurs.
Figure 3-27.
3-33
Chapter 3 Configure the Internet
TCP AND UDP.
WAN End Port must be specified
ZTE Proprietary and Confidential
DDNS