Daikin RXYQ-TA Series Service Manual page 164

Field Settings for Outdoor Unit
[2-32]: Forced, all time, power consumption limitation operation (no external control adaptor is required to
perform power consumption limitation)
If the system always needs to be running under power consumption limitation conditions, this setting
activates and defines the level power consumption limitation that will be applied continuously. The level is
according to the table.
0 (default)
[2-34]: Indoor fan tap setting
Indoor fan speed limitation related to connection capacity and outdoor air temperature for energy saving.
0 (default)
[2-35]: Height difference setting
Default value: 1
In case the outdoor unit is installed in the lowest position (indoor units are installed on a higher position
than outdoor units) and the height difference between the highest indoor unit and the outdoor unit exceeds
40 m (131 ft), the setting [2-35] should be changed to 0.
151
Value
[2-32]
1
2
Value
[2-34]
Fan speed is limited to L tap when indoor units
capacity ≥ 130%.
In heating mode, fan speed is limited to L tap
1
when indoor units capacity ≥ 130%.
Fan speed follows a setting of the remote
2 controller (not limited by indoor units connection
capacity).
Fan speed is limited to L tap when outdoor air
temperature goes down to below 29.5°C
3 (85.1°F). It returns to remote controller setting
when outdoor air temperature goes up to over
32.5°C (90.5 °F).
Fan speed is limited to L tap when outdoor air
temperature goes down to below 23.5°C
4 (74.3°F). It returns to remote controller setting
when outdoor air temperature goes up to over
26.5°C (79.7°F).
Fan speed is limited to L tap when outdoor air
temperature goes down to below 19.3°C
5 (66.7°F). It returns to remote controller setting
when outdoor air temperature goes up to over
22.3°C (72.1°F).
Restriction reference
Function not active
Follows [2-30] setting
Follows [2-31] setting
Indoor fan tap setting
SiUS341615E
Field Settings