Page 1
OPERATION MANUAL System air conditioner English MODEL RXYQ72TATJU RXYQ72TAYDU RXYQ96TATJU RXYQ96TAYDU RXYQ120TATJU RXYQ120TAYDU Français RXYQ144TATJU RXYQ144TAYDU RXYQ168TATJU RXYQ168TAYDU RXYQ192TATJU RXYQ192TAYDU RXYQ216TATJU RXYQ216TAYDU Español RXYQ240TATJU RXYQ240TAYDU RXYQ264TATJU RXYQ264TAYDU RXYQ288TATJU RXYQ288TAYDU RXYQ312TATJU RXYQ312TAYDU RXYQ336TATJU RXYQ336TAYDU RXYQ360TATJU RXYQ360TAYDU RXYQ384TATJU RXYQ384TAYDU RXYQ408TATJU RXYQ408TAYDU Read these instructions carefully before installation. Keep this manual in a handy place for future reference.
Page 2
Only use accessories Inform customers that they should store this Operation made by Daikin that are specifically designed for use Manual with the Installation Manual for future reference. with the equipment and have them installed by a Meanings of DANGER, WARNING, CAUTION, and NOTE professional.
Page 3
• Although this is a recognized measure for additional • Do not expose the controller to direct sunlight. The protection, with the grounding system in North LCD display can become discolored and may result in America, a dedicated GFCI may not be necessary. fail to display the data.
Page 4
Safety Considerations [Place of Installation] • Make sure that the air conditioner is located in a sufficiently ventilated place not surrounded by obstacles. • Do not use the air conditioner in the following places. a. Places with a mist of mineral oil, such as cutting oil. b.
Specifications This table shows the specifications of the single module. For the specifications of the multi module system, refer to the specifications of each single module that constitutes the system. Model name RXYQ72TATJU RXYQ96TATJU RXYQ120TATJU RXYQ144TATJU RXYQ168TATJU Power supply Phase —...
What to do before Operation This operation manual is for the following system with standard control. Before initiating operation, contact your local dealer for the operation that corresponds to your system type. If your installation has a customized control system, ask your local dealer for the operation that corresponds to your system. 1.
Operation Procedure • Operation procedure varies according to the combination of outdoor unit and remote controller. Read the chapter “What to do before Operation”. • Do not turn off the power supply during the air conditioning season for starting operation smoothly. •...
Basic Operation Dry Mode Preparation • For equipment protection purposes, apply power to the outdoor units at least 6 hours before starting the operation of the system. • The dry mode may not be selected if the remote controller is master controlled and the system is not already in the cooling mode of operation (see the following section).
Maintenance Reset Filter Indicator Operation • When it is time to clean or replace the filter, one of the following messages will appear on the bottom of the basic screen. Cool Set to Cool “Time to clean filter” “Time to clean filter & element” Time to clean filter “Time to clean element”...
Reference Information Error Code Display Contact your local dealer in the following cases Operation • If an error occurs, either one of the following items will flash in the basic screen. Cool “Error: Press Menu button” Set to Cool * The operation lamp will flash. Operation “Warning: Press Menu button”...
Optimum Operation Observe the following precautions to ensure the system operates properly. • Prevent direct sunlight from entering a room during cooling operation by using curtains or blinds. • Do not leave doors and windows open. If the doors and windows remain open, air will flow out of your room causing a decrease in the cooling or heating effect.
Following Issues Do Not Mean System Malfunction The system does not operate • The air conditioner does not start immediately when restarting or changing the operation mode. If the operation lamp lights, the system is in normal condition. To prevent overloading of the compressor motor, the air conditioner starts 5 minutes after it is turned ON again in case it was turned OFF just before.
Page 14
Following Symptoms are not Air Conditioner Troubles White mist comes out of the unit Indoor unit • When humidity is high during cooling operation. If the interior of indoor unit is extremely contaminated, the temperature distribution inside a room becomes uneven. It is necessary to clean the interior of the indoor unit.
Hot air is emitted even though the unit is stopped • Hot air can be felt when the unit is stopped. Several different indoor units are being run on the same system, so if another unit is running, some refrigerant will still flow through the unit. Does not cool very well •...
Trouble Shooting • Check the fan speed setting on your remote controller. Refer to “Operation Procedure”. • Check for open doors or windows. Shut doors and windows to prevent wind from coming in. • Check if there are too many occupants in the room during cooling operation. •...
Page 17
• Table 1 “Inspection Cycle” and “Maintenance Cycle” Lists Name of Main Part Inspection Cycle Maintenance Cycle [replacements and/or repairs] Compressor 20,000 hours Electric motor (fan, damper, etc.) 20,000 hours PC boards 25,000 hours Heat exchanger 5 years Sensor (thermistor, etc.) 5 years 1 year Remote controller and switches...