Daikin RXYQ-TA Series Service Manual page 11

Heat pump 60 hz
Table of Contents

Advertisement

SiUS341615E
Safety Cautions
Warning
When wiring between the indoor and outdoor units, make sure that the
terminal cover does not lift off or dismount because of the cable.
If the cover is not mounted properly, the terminal connection section may cause
an electrical shock, excessive heat generation or fire.
Do not damage or modify the power cable.
Damaged or modified power cables may cause an electrical shock or fire.
Placing heavy items on the power cable, or heating or pulling the power cable
may damage it.
Do not mix air or gas other than the specified refrigerant (R-32, R-410A,
R-22) in the refrigerant system.
If air enters the refrigerating system, excessively high pressure results, causing
equipment damage and injury.
If the refrigerant gas leaks, be sure to locate the leakage and repair it
before charging the refrigerant. After charging the refrigerant, make sure
that there is no leakage.
If the leakage cannot be located and the repair work must be stopped, be sure
to pump-down, and close the service valve, to prevent refrigerant gas from
leaking into the room. Refrigerant gas itself is harmless, but it may generate
toxic gases when it contacts flames, such as those from fan type and other
heaters, stoves and ranges.
When relocating the equipment, make sure that the new installation site
has sufficient strength to withstand the weight of the equipment.
If the installation site does not have sufficient strength or if the installation work
is not conducted securely, the equipment may fall and cause injury.
Check to make sure that the power cable plug is not dirty or loose, then
insert the plug into a power outlet securely.
If the plug is dusty or has a loose connection, it may cause an electrical shock
or fire.
When replacing the coin battery in the remote controller, be sure to
dispose of the old battery to prevent children from swallowing it.
If a child swallows the coin battery, see a doctor immediately.
Caution
Installation of a leakage breaker is necessary in some cases depending
on the conditions of the installation site, to prevent electrical shocks.
x

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents