Parameter Options; Default Settings - Danfoss VLT AQUA High Power Operation Instructions Manual

5 How to programme the frequency converter
29-05 Filled Setpoint
Range:
0 s* [0 – 999999,999 s]

5.3 Parameter Options

5.3.1 Default settings

Changes during operation:
"TRUE" means that the parameter can be changed while the frequency converter is in operation and "FALSE" means that the frequency converter must
be stopped before a change can be made.
5
4-Set-up:
'All set-up': the parameter can be set individually in each of the four set-ups, i. e. one single parameter can have four different data values.
'1 set-up': data value will be the same in all set-ups.
SR:
Size related
Conversion index:
This number refers to a conversion figure used when writing or reading by means of a frequency converter.
Conv. index 100
Conv. factor 1
Data type
2
3
4
5
6
7
9
33
35
54
138
Function:
Specifies the Filled Set-point at which the Pipe Fill Function will be disabled and the PID controller
will take control. This function can be used both for horizontal and vertical pipe systems.
67 6 5 4
1/60 1000000 100000 10000
Description
Integer 8
Integer 16
Integer 32
Unsigned 8
Unsigned 16
Unsigned 32
Visible String
Normalized value 2 bytes
Bit sequence of 16 boolean variables
Time difference w/o date
MG.20.P3.02 - VLT
VLT AQUA High Power Operation Instructions
N/A:
No default value available.
3 2 1 0 -1
1000 100 10 1 0.1
®
is a registered Danfoss trademark
-2 -3 -4 -5
0.01 0.001 0.0001 0.00001 0.000001
Type
Int8
Int16
Int32
Uint8
Uint16
Uint32
VisStr
N2
V2
TimD
-6