How To Install; How To Get Started; Pre-Installation; Planning The Installation Site - Danfoss VLT AQUA High Power Operation Instructions Manual

VLT AQUA High Power Operation Instructions

3 How to Install

3.1 How to Get Started

3.1.1 About How to Install
This chapter covers mechanical and electrical installations to and from power terminals and control card terminals.
options
Electrical installation of is described in the relevant Operating Instructions and Design Guide.
3.1.2 How to Get Started
The frequency converter is designed to achieve a quick and EMC-correct installation by following the steps described below.
Read the safety instructions before installing the unit.
Mechanical Installation
• Mechanical mounting
Electrical Installation
• Connection to Mains and Protecting Earth
• Motor connection and cables
• Fuses and circuit breakers
• Control terminals - cables
Quick setup
• Local Control Panel, LCP
• Automatic Motor Adaptation, AMA
• Programming
Frame size is depending on enclosure type, power range and mains volt-
age

3.2 Pre-installation

3.2.1 Planning the Installation Site

NB!
Before performing the installation it is important to plan the installation of the frequency converter. Neglecting this may result in extra
work during and after installation.
Illustration 3.1: Diagram showing basic installation including
mains, motor, start/stop key, and potentiometer for speed
adjustment.
®
MG.20.P3.02 - VLT is a registered Danfoss trademark
3 How to Install
3
13