Step 1: Mounting The Workpiece - Roland DWX-4W User Manual

Starting Milling

CAUTION

STEP 1: Mounting the Workpiece

Procedure

Check that the

If the power is off, close the front cover and turn on the power.
 P. 16 "Switching the Power On"

Once initialization completes, open the front cover.



Close the front cover.
24
2. Milling
Do not insert your hands or other objects into the machine or look into the inside
of the machine with the front cover open until the spindle has come to a complete
stop.
If you open the front cover before the spindle comes to a complete stop, an emer-
gency stop will occur. Due to inertia, the spindle will continue to rotate even after
an emergency stop has occurred. It is dangerous to touch a rotating tool. Also, the
coolant continues to flow until the spindle comes to a complete stop. Coming into
contact with sprayed coolant may be hazardous to your health.
P. 23 "STEP 0: Spindle Run-In (Short)"
OK Not OK
When the message shown in the figure appears,
the spindle run-in (short) is complete.
Click [OK].
procedure is complete.
Insert the pin portion of the workpiece
into the hole on the rotary axis.
Align the notch on the base of the workpiece pin
with the protrusion on the rotary axis.
Use a mounting screw to secure the
workpiece in place.
Tighten with a hexagonal screwdriver.