Milling Bur Change Test - Roland DWX-4W User Manual



Close the front cover.


Milling Bur Change Test

Check whether the milling bur has been set in the correct position at the correct length.
Procedure

Verify the milling bur is set in the ATC magazine.

P. 17 "Preparing a Milling Bur"

Show VPanel.

P. 5 "Displaying VPanel"

Periodic Care and Maintenance
Set the dummy pin for milling in the
ATC magazine's "D" stocker.
The detection pin should be oriented with the
tapered end up. Be careful not to confuse which
side is up and which is down.
If the message shown in the following
figure appears, click [OK].
Select a machine to operate.
Click the radio button to the left of the name of
the machine to operate.
Click in the top window.
The [Settings] screen will appear.
3. Maintenance
45