Roland DWX-4W User Manual page 58

Extended Periods of Non-Use / Moving the Machine



CAUTION
58
3. Maintenance
Do not insert your hands or other objects into the machine or look into the inside
of the machine with the front cover open until the spindle has come to a complete
stop.
If you open the front cover before the spindle comes to a complete stop, an emer-
gency stop will occur. Due to inertia, the spindle will continue to rotate even after
an emergency stop has occurred. It is dangerous to touch a rotating tool. Also, the
coolant continues to flow until the spindle comes to a complete stop. Coming into
contact with sprayed coolant may be hazardous to your health.
If a workpiece or the automatic cor-
rection jig is attached:
Remove the workpiece or the auto-
matic correction jig, close the front
cover, and then click [OK].
If no workpiece or automatic correc-
tion jig is attached:
Click [OK].
Open the front cover.
Spin the spindle around 10 times
in either direction by hand.
Close the front cover.
Spindle run-in will begin.
The machine status light will flash blue. The re-
maining work time will be displayed on VPanel.
When the message shown in the figure appears,
the spindle run-in (long) is complete.
Click [OK].