Compressed Air Does Not Come Out; Automatic Correction Fails; The Milling Bur Management Information Was Lost - Roland DWX-4W User Manual

Compressed Air Does Not Come Out

Is the power switched on?
Is the regulator properly connected and
the pressure settings correctly configured?
Is the air supply hose bent or flattened?

Automatic Correction Fails

Is the automatic correction jig or detection
pin dirty?
Is the automatic correction jig properly
attached?

The Milling Bur Management Information was Lost

Was the machine name (printer name)
changed?
Compressed air is not supplied when the power is off.
Check the connection. If there are no connection problems,
check whether the regulator scale indicates zero. If the set
pressure of the regulator is zero, compressed air will not be
supplied.
 "Setup Guide" ("Preparing the Regulator")
If the hose is bent or flattened, straighten it to enable the flow
of compressed air.
Clean away any grime on the automatic correction jig, the
detection pin, or the milling bur sensor tip (the side that is
in contact with the milling bur). Fouling due to buildup of
milling waste or the like on any of these may impede correct
sensor operation, making correct detection impossible.
Verify that the automatic correction jig is properly attached.
Milling bur info is saved per machine name (printer name).
Before changing the machine name (printer name), make
sure to record the milling bur info separately. Milling bur info
can be recovered by returning the machine name (printer
name) to the original name.
Machine Problems
-
P. 17
-
P. 39
P. 39
-
4. Troubleshooting
67