Table of Contents
Advertisement
Hold this with
both hands.
Collet
replacement jig
If a workpiece or the automatic
correction jig is attached:
Remove the workpiece or the automatic
correction jig, close the front cover, and
then click [OK].
If no workpiece or automatic
correction jig is attached:
Click [OK].
The window shown in the figure
appears automatically.
Open the front cover.
Press the collet replacement jig
against the collet, and then insert
the collet tap.
Align the hexagonal tip of the collet and the
hexagonal portion of the collet replacement jig.
Important
Rotate the collet replacement jig while the
collet tap is inserted. If the collet replacement
jig is rotated without the collet tap inserted,
the collet may be damaged.
Collet tap
While gently pressing the collet tap up
into the hole, rotate the collet replacement
jig in the direction indicated in the figure.
Rotate the collet replacement jig until the collet
naturally comes free.
Due to the pressure of the compressed
air, the collet may be forcefully pushed
out when it comes free. Gently support
the collet with your hand so that the
collet does not fall out.
Following Daily Operations
2. Milling
29
Hide quick links:
Advertisement
Table of Contents
