Table of Contents
Advertisement
Close the front cover.
Wipe the removed dummy pin for milling with a dry cloth.
Any fluid or milling waste not wiped off will have an effect on the milling results. Carefully wipe the entire area clean.
2.
Perform automatic correction of the milling machine.
Hold this with
both hands.
Use a dry cloth to cleanly wipe away any fluid or dirt in the locations shown in the follow-
ing figure.
If any fluid or dirt is present in these locations, correction might not occur properly.
Detection pin for correction
and spindle head
Automatic correction jig
Periodic Care and Maintenance
If the message shown in the following
figure appears, click [OK].
Open the front cover.
Milling bur sensor
(contact side of the milling bur)
Part to be wiped
3. Maintenance
41
Hide quick links:
Advertisement
Table of Contents
