Using/Reading The Built-In Panel; Statuses Indicated By Status Light Color - Roland DWX-4W User Manual

Using/Reading the Built-In Panel

Using/Reading the Built-In Panel

POWER
This lights up when the power is turned on.
Illuminates when operation is paused. Flashes when operation is ongoing (from the point when
PAUSE
the operation button is pressed during milling to the point when operation is paused).
ERROR
Flashes when an error has occurred.
Flashes when data is being cancelled and during initialization.
CANCEL
Milling data received while this light is flashing will be cancelled.
Pressing this button during milling will pause or restart the machine.
Operation button
Pressing and holding this button during milling will abort milling or clear some errors.
Pressing this button in standby will rotate the rotary axis position 180 degrees.
The button will flash during initialization, spindle head or rotary axis operation, spindle rotation, and
maintenance operation. The button will illuminate under any other status while the power is on.

Statuses Indicated by Status Light Color

Initialization is in progress or the machine is in the standby status. (In the standby status, the color will
change to white when the front cover is opened.)
Blue
In the standby status, if no operation is initiated within 5 minutes, the machine will change to the sleep
status, and the status light will turn off.
Milling is in operation or is paused. Also, in the standby status, white light will illuminate when the front
White
cover is opened.
When lit yellow, an error has occurred, and the machine has been paused.
Yellow
Check the error details shown on VPanel. Press the operation button on the built-in panel to resume milling.
When lit or flashing red, an error has occurred and milling has been stopped. Milling cannot be resumed.
Check the error details shown on VPanel. When illuminated, pressing and holding the operation button on
Red
the built-in panel will cancel milling and return the machine to the ready status. When flashing, turn off the
power once and start up the machine again.
Off
The machine is sleeping or the power has been turned off and all lights are out.
Status light
2. Milling
15