Roland DWX-4W User Manual page 80

Responding to Error Messages
Error number
1023-0000 Milling data er-
ror. The number
of parameters is
incorrect.
1024-0000 Milling data error.
The parameter is
out of range.
1025-0000 Milling data er-
ror. A wrong com-
mand is detected.
1026-0000 Milling data er-
ror. The address
is not defined.
1027-0000 Milling data er-
ror. The parame-
ter is not defined.
1028-0000 Milling data er-
ror. The opera-
tion cannot be
executed.
1029-**** The spindle ex-
p e r i e n c e d a n
overload.
102A-0000 The spindle ex-
perienced over-
current.
102B-0000 The spindle mo-
tor temperature
is high.
103C-0000 The spindle tem-
perature is high.
1035-0000 The spindle con-
trol circuit tem-
perature is high.
102D-0000 The spindle does
not turn.
1038-0000 Milling data er-
ror. No milling
bur is selected.
80
4. Troubleshooting
Message Situation/error cause
There may be a problem
with the milling data re-
ceived from the computer.
Alternatively, the data
transfer may have failed
due to the computer being
under a high load.
The spindle stopped under
a large milling load or other
causes. The following are
likely reasons.
• The milling bur is worn.
• A workpiece that cannot
be milled by the machine
is being used.
• The milling conditions are
too strict.
• The spindle is defective.
The cable may be broken
or the spindle unit may be
defective.
There is a problem with the
specified milling bur details
in the milling data.
Action
1. Press and hold the operation button on the built-
in panel. This will clear the error.
2. Check the milling data.
If there are no problems with the milling data
1. Exit any unnecessary programs.
2. Restart the computer, and then perform milling
again.
1. Turn off the power.
2. Check the milling bur, the workpiece, and the
CAM settings as well as the shape specified in the
milling data.
3. Allow the machine to rest for some time before
turning the power on because the motor may have
overheated.
If there are no problems with the milling bur, work-
piece, or milling conditions, the spindle unit may
be defective. Replace the spindle unit with a new
one. After you replace the spindle unit, correct the
milling machine.

P. 49 "Replacing the Spindle Unit",
Machine Correction"
Turn off the power and contact your authorized
Roland DG Corporation dealer.
1. Press and hold the operation button on the built-
in panel. This will clear the error.
2. Check the milling data.

P. 39 "Milling