Roland DWX-4W User Manual page 82

Responding to Error Messages
Error number
1034-0000 The coolant tank
is not installed.
103B-0000 The automatic
correction is not
yet finished.
103A-**** D A N G E R ! !
The coolant is
leaking!!
82
4. Troubleshooting
Message Situation/error cause
The coolant tank may have
been removed during ma-
chine operation.
Automatic correction may
not have been performed.
Automatic correction may
have been cancelled before
it could finish.
Automatic correction may
not have been performed
after updating the firm-
ware to a version that re-
quired automatic correc-
tion to be performed again.
The versions of VPanel and
the machine's firmware
may not match.
Fluid may be leaking inside
the machine.
Action
1. Correctly attach the coolant tank. You have to
push the coolant tank until you feel it click into
place.
2.
If the error occurred during milling
Press the built-in panel's operation button. Resume
milling.
If the error occurred outside of milling
Press and hold the built-in panel's operation but-
ton.
1. Press and hold the operation button on the built-
in panel. This will clear the error.
2. Perform automatic correction.

P. 39 "Milling Machine Correction"
Download the latest versions of VPanel and the
machine's firmware from our special Easy Shape
website (http://www.rolandeasyshape.com), and
then install these versions.
Turn off the power and unplug the power cable.
After that, contact your authorized Roland DG
Corporation dealer.