Roland DWX-4W User Manual page 26

Starting Milling

Changing the data list order
You can change the output order by selecting the milling data in the data list and clicking
(The milling data is output from the top of the data list.)
Removing milling data in the data list
You can remove milling data in the data list by selecting the milling data and clicking "Remove."
Adding milling data by dragging and dropping
You can add milling data by dragging and dropping data on the window displayed in steps


When milling is finished, a completion buzzer will sound.
Check that the spindle has come to a complete stop, and then open the front cover.
CAUTION
CAUTION
Continue on to
26
2. Milling
Do not insert your hands or other objects into the machine or look into the inside of
the machine with the front cover open until the spindle has come to a complete stop.
If you open the front cover before the spindle comes to a complete stop, an emergency
stop will occur. Due to inertia, the spindle will continue to rotate even after an emergency
stop has occurred. It is dangerous to touch a rotating tool. Also, the coolant continues
to flow until the spindle comes to a complete stop. Coming into contact with sprayed
coolant may be hazardous to your health.
After milling, thoroughly wash the products with purified water or a similar substance.
After milling, there will be coolant on the product. Using the product as is may cause
an inflammation or the like.
P. 28 "Following Daily Operations"
Click [Output].
Verify that a workpiece and milling
bur have been mounted on the milling
machine, and click [OK].

The output milling data is displayed in the output
list of the top window, and milling starts.
The estimated milling time and a progress bar are
displayed next to the machine name.
.
or
 
and
P. 24 "STEP 1: Mounting the Workpiece"
.
.