Roland DWX-4W User Manual page 78

Responding to Error Messages
Error number
101E-0000 The milling bur
might be broken.
101F-0000 The milling bur
chucking has
slipped out.
1020-0000 The milling bur
is too long.
78
4. Troubleshooting
Message Situation/error cause
The milling bur might be
broken.
The milling bur might be
out of position.
The inside of the collet
might be dirty.
The collet may have worn
out.
The milling bur holder
might be out of position.
The milling bur might have
been shortened due to
wear.
The inside of the collet
might be dirty.
The collet may have worn
out.
The milling bur in use
might not be a dedicated
product.
The milling bur holder
might be out of position.
Action
1. Press and hold the button on the machine to
clear the error.
2. If the milling bur is broken or if it is out of position,
replace it with a new milling bur.
3. The milling conditions may be excessively strict,
so review them.
4. If the error occurs even after you review the
milling conditions, perform collet maintenance.
Carefully clean the inside of the collet.

P. 23 "STEP 0: Spindle Run-In (Short)"
If the error occurs again even after you perform the
above operations, the collet may have worn out,
leading to a decrease in its retention capabilities.
Replace the collet with a new one. After you replace
the collet, correct the milling machine.

P. 53 "Replacing the Collet", P. 39 "Milling Machine
Correction"
1. Follow the messages displayed in VPanel to forc-
ibly release the milling bur.
2. If the milling bur has been shortened due to
wear or if the holder is out of position, replace the
milling bur.
3. The milling conditions may be excessively strict,
so review them.
4. If the error occurs even after you review the
milling conditions, perform collet maintenance.
Carefully clean the inside of the collet.

P. 23 "STEP 0: Spindle Run-In (Short)"
If the error occurs again even after you perform the
above operations, the collet may have worn out.
Replace the collet with a new one. After you replace
the collet, correct the milling machine.

P. 53 "Replacing the Collet", P. 39 "Milling Machine
Correction"
1. Set the correct milling bur in the stocker.
2.
If the error occurred during milling
Close the front cover, and press the built-in panel's
operation button. Resume milling.
If the error occurred outside of milling
Close the front cover, and then press and hold the
built-in panel's operation button. This will clear
the error.
1. Replace the milling bur with a new one.
2.
If the error occurred during milling
Close the front cover, and press the built-in panel's
operation button. Resume milling.
If the error occurred outside of milling
Close the front cover, and then press and hold the
built-in panel's operation button. This will clear
the error.