Replacing Consumable Parts
Replacing the Spindle Unit
Recommended Replacement Interval
When the total work time of the spindle exceeds 2,000 hours (with variation depending on the work situation).
The spindle unit is a part that wears out. You can use VPanel to view the total work time of the spindle. Refer to VPanel to de-
termine when replacement is needed. Contact your authorized Roland DG Corporation dealer when it is time for replacement.
Milling Bur Service Life
Necessary Replacement Interval
Work time : Approx. 7 hours
The work time for each milling bur can be viewed on VPanel.
P. 12 ""Milling bur management" Dialog Box"
The milling bur is a consumable part. Contact your authorized Roland DG Corporation dealer when it is time for replacement.
Replacing the Coolant Tank Filter
Contact your authorized Roland DG Corporation dealer to purchase new filters.
CAUTION
Do not overfill or tilt the coolant tank.
The fluid inlet on the coolant tank is open. Overfilling or tilting will cause fluid to
spill out.
CAUTION
When raising or lowering the coolant tank,
hold the positions indicated in the following figure.
Failing to do so may result in your fingers being pinched,
leading to injury.
Situations Requiring This Work
When the filter is dirty
Once a month (varies with work conditions)
Required Tools
Optional part
Filter
49
3. Maintenance