Close the front cover.
The window shown in the figure appears auto-
matically.
Open the front cover and remove the
dummy pin for milling.
Wipe the dummy pin for milling with
a dry cloth.
Any fluid or milling waste not wiped off will have
an effect on the milling results. Carefully wipe the
entire area clean.
Return the dummy pin for milling to the
ATC magazine's "D" stocker.
The detection pin should be oriented with the
tapered end up. Be careful not to confuse which
side is up and which is down.
The operation is complete once the message in
the figure is displayed.
Click [OK].
3. Maintenance
Daily Care
37