Coil Tine Harrow Installation - Landoll 2131 Operator's Manual

Coil Tine Harrow Installation

See Figures 2-20 thru 2-22 for 3 Row Coil Tine Harrow
placement dimensions.
1. Install 2 hole support plate into coil tine harrow arm
assembly. Use (2) 3/4-10 x 3 hex head cap screws to
hold plate in place.
2. Slide coil tine harrow arm assemblies over rear frame
bar using chopper reel placement drawings (See
Figures 2-20 thru 2-22 and 3-34.)
3. Attach top plate to top of chopper reel arm assembly
using (4) 3/4-10 x 13 hex head cap screws. Slide arm
support tube and bottom plate onto 13" hex head cap
screws on underside of chopper reel arm assembly
and rear frame (See Figure 3-34.)
4. Evenly tighten the 3/4-10 x 13 hex head cap screws
first. Then tighten the front 3/4-10 x 2 hex head cap
screw. Tighten 3/4-10 x 3 hex head cap screws last,
but be sure to not overtighten. These screws need to
be snug.
5. Adjust spring to 21-1/2" (See Figure 3-35.)
6. Attach harrow arms to 3 row coil tine harrow
assembly using u-bolts, and 5/8-11 flange head
serrated nuts. The u-bolt will go through both the
harrow arm and harrow stiffener plate.
ASSEMBLY INSTRUCTIONS
21-1/2"
2130-21-tine-2
Figure 3-35: Coil Tine Arm Spring Adjustment
3-41