Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
Coulter Gang Installation
Coulter blades are extremely sharp. Exercise
extreme care when working on or near coulter
blades. Do not allow coulters to roll over or fall
onto any body part. Do not allow wrenches to slip
when working near coulter blades. Never push
wrenches toward coulter blades. Do not climb
over machine above coulter blades. Failure to
stay clear of coulter blade edges can cause
serious personal injury or death.
1. Attach the coulter gang assemblies to the center and
wing frames using shank pin, 1-8 hex lock nut, and
1/2 x 2-1/4 grooved alloy pin (See Figure 3-7.)
2. Attach the base end of the 4 x 8 master cylinder to
the coulter spring rod assembly attached to the left
wing frame weldment using the clevis pins and roll
pins which come with the cylinder and a steel
bushing.
3-12
DANGER
3. Attach the base end of the 3-3/4 x 8 slave 1 cylinder
to the coulter spring rod assembly attached to the left
center frame weldment using the clevis pins and roll
pins which come with the cylinder and a steel
bushing.
4. Attach the base end of the 3-1/2 x 8 slave 2 cylinder
to the coulter spring rod assembly attached to the
right center frame weldment using the clevis pins and
roll pins which come with the cylinder and a steel
bushing.
5. Attach the base end of the 3-1/4 x 8 slave 3 cylinder
to the coulter spring rod assembly attached to the
right wing frame weldment using the clevis pins and
roll pins which come with the cylinder and a steel
bushing.
6. Connect the rod ends of each cylinder to the gang
bar cylinder anchor plate using the clevis pins and
roll pins which come with each cylinder.
o
7. Install 90
adapters into both ports of the 4 x 8
master cylinder, 3-3/4 x 8 slave 1 cylinder, 3-1/2 x 8
slave 2 cylinder, and the base end port of the 3-1/4 x
8 slave 3 cylinder.
o
8. Install 90
elbow w/ restrictor into the rod end of the
3-1/4 x 8 slave 3 cylinder.
F-721-0513
Advertisement
Table of Contents
