Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
WIRE DESIGNATIONS FOR MAIN HARNESS
7-PIN
4-PIN
CIRCUIT
CONN
TOWER
1
D
GROUND
2
WORK LAMPS
3
B
LEFT FLASHING
& TURN
4
STOP LAMPS
5
A
RIGHT FLASHING
& TURN
6
C
TAIL LAMPS
7
SWITCHED
POWER (12V)
m177037 wire designations op
Figure 3-22: LED Light and SMV Harness Wire Designations (After August, 2013)
LED Light and SMV Bracket
Installation (After August, 2013)
NOTE
See Figures 2-1 thru 2-16 for light bracket placements.
1. Attach left and right light brackets with reflectors to
center frame using u-bolts and hex lock nuts (See
Figure 3-21.)
2. Attach ag amber single LED lamps to light brackets
using 1/4-20 x 1-1/4 hex head cap screws and hex
lock nuts.
3. Attach left tail light mount to frame assembly using
u-bolt and 5/8-11 flange head serrated nuts.
4. Attach right tail light mount and ag flasher control
module to frame assembly using u-bolt and 5/8-11
flange head serrated nuts. Be sure that the control
module is set so that the 6 pin connector faces the
right side of the machine.
5. Attach the ag red single LED lamps to tail light
mounts using 1/4-20 x 1-1/4 hex head cap screws
and hex lock nuts.
3-30
WIRE DESIGNATIONS FOR REAR HARNESS
WIRE
COLOR
GROUND
BLACK
YELLOW
RED
GREEN
BROWN
BLUE
IMPORTANT
Make sure lights are positioned for maximum
visibility from the rear.
6. Install the rear warning light harness to the frame.
7. Attach front warning harness to frame. Connect 4 pin
8. Insure that the harnesses are clear of any moving
9. Install the stor-away holder to hose holder on hitch
10. Attach SMV emblem and mounting bracket to rear
1
2
2-PIN
3-PIN
TOWER
TOWER
A
A
B
B
C
Connect 2 pin and 3 pin ends to each of the warning
lights. Connect 6 pin to the ag flasher control module.
See Figure 3-22 for LED harness wire
designations.
end to the ag flasher control module.
parts and secure the harnesses with tie wraps
provided.
with 1/4-20 x 3/4 hex head cap screws and hex lock
nuts.
center frame bar using u-bolt, 1/4-20 x 3/4 hex head
cap screws, and hex lock nuts. The SMV sign should
be centered on the back bar of the frame.
3
4
5
6-PIN
3-PIN
2-PIN
SHROUD
TOWER
TOWER
A
C
B
A
A
C
B
B
D
E
F
F-721-0513
Advertisement
Table of Contents
