How To Attach A Chassis Ground Connection - Cisco SCE 1000 Installation And Configuration Manual

Chapter 4 Installation and Maintenance

How to Attach a Chassis Ground Connection

Before you connect the power or turn on the power to the SCE 1000 platform, it is required that you
provide an adequate chassis ground (protective earth) connection for the SCE 1000 chassis. A grounding
kit is provided with each SCE 1000.
Use the grounding kit to properly ground the SCE 1000 chassis.
Note When installing the unit, the chassis ground connection must always be made first and disconnected last.
From the enclosed grounding kit, remove the necessary materials—the grounding cable (green and
Step 1
yellow colored cable) and pairs of hex nuts and spring washers.
Step 2 On the rear panel of the SCE 1000, locate the chassis grounding connector (refer to the appropriate figure
for an AC- or DC-powered SCE 1000 below).
Attach the grounding cable (green and yellow colored cable), firmly fastening the (enclosed) hex nuts
Step 3
and spring washers with a #¼" hex wrench (refer to the appropriate figure
for an AC- or DC-powered SCE 1000 below).
The other side of the grounding cable must be connected to the site equivalent of the AC earth.
Figure 4-12
OL-26790-01
Grounding the Unit (AC)
BY PA SS
1
IN
PO W ER B
OK
IN
PO W ER A
OK
1 2
How to Attach a Chassis Ground Connection
Cisco SCE 1000 2xGBE Installation and Configuration Guide
(Figure 4-12 or Figure 4-13)
4-13