External Optical Bypass Module Front Panel - Cisco SCE 1000 Installation And Configuration Manual

Appendix A External Optical Bypass Module
Figure A-2
Switch

External Optical Bypass Module Front Panel

The front panel of the External Optical bypass module
•
•
•
•
•
Figure A-3
OL-26790-01
External Bypass Module: in bypass
Tx
SUB Rx/Tx — GBE port that connects to the network element on the Subscriber side of the link.
NET Rx/Tx — GBE port that connects to the network element on the Network side of the link.
CONTROL — RJ-45 port that connects to the Bypass connector on the rear panel of the SCE 1000
platform. The SCE 1000 platform controls the External Optical Bypass module via this connection,
by the presence or absence of electrical power.
Pigtail fiber connectors — Four fiber cables that connect to the GBE link ports on the front panel of
the SCE 1000 platform
– NET Tx
NET Rx
–
SUB Tx
–
SUB Rx
–
No Bypass LED:
ON = Bypass module is not active (GBE traffic flows through the SCE 1000 platform)
–
OFF = Bypass module is active (GBE traffic flows through the bypass module)
–
Front Panel of the External Optical Bypass Module
1
Sub
Tx Rx
External optical
bypass module
Sub Net
Rx Tx Rx
PWR A
PWR B STATUS BYPASS
MNG 1 Cisco SCE
MNG 2 CONSOLE 1000
LINK/ 10/100/ AUX LINK RX TX 2xGB E Series
ACTIVE 1000 LINK/ ACTIVE 10/100/ LINK RX TX
1000
RX MM TX
RX MM TX
GBE-1
SUB LINE
NET
SCE 1000 2xGBE
(Figure
2
Net
Tx Rx
Cisco SCE 1000 2xGBE Installation and Configuration Guide
External Optical Bypass Module Front Panel
Router
Control No Bypass
A-3) contains the following components:
3 4 5
Control No Bypass
A-3