Step 10: Completing And Saving The Configuration - Cisco SCE 1000 Installation And Configuration Manual

Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
Example 3:
Following is a sample topology configuration for a redundant inline topology.
•
•
•
Would you like to enter the Topology configuration menu? [no]: y
Enter Connection mode:
1- inline
2- receive-only
Enter your choice [1]: 2
Enter On-failure behavior:
1- Bypass
2- Cutoff
Enter your choice [1]:2
Enter admin status of the SCE after abnormal boot:
1- Operational
2- Not-Operational
Enter your choice [1]:
Data collection for the system configuration is completed.

Step 10: Completing and Saving the Configuration

When you have completed the entire configuration, the system checks for errors. If errors are found, a
warning message appears. When the configuration is error-free, you may apply and save it.
To complete and save the configuration, complete the following steps:
Review the new configuration.
Step 1
The system informs you that data collection is complete.
We recommend that you view the entire new configuration before it is applied.
Type y and press Enter.
Note that there is no default.
If there are no errors, go to step 3.
Data collection for the system configuration is completed.
Would you like to view the new configuration before it is applied? [yes/no]: y
View errors (if any).
Step 2
If any errors are detected, you may choose to view them.
Press Enter.
Found errors in the new configuration, would you like to view them? [yes]:
The following errors were found:
Warning - RDR formatter destination 10.1.1.1 is not allowed in the IP access-class.
OL-26790-01
Connection mode—Inline
For a redundant topology, link bypass on-failure should be Cutoff, so that operation switches to the
backup link.
After operation of the system resumes, and the reboots, the SCE 1000 will resume operation.
(Admin status after abnormal reboot is Operational.)

Step 10: Completing and Saving the Configuration

Cisco SCE 1000 2xGBE Installation and Configuration Guide
5-23