Perform The Initial System Configuration; Initial System Configuration; Setup Command - Cisco SCE 1000 Installation And Configuration Manual

Perform the Initial System Configuration

Perform the Initial System Configuration
•
•
•
•
•
•
•
•
•
•
•

Initial System Configuration

•
•
•

Setup Command

Upon initial connection to the local terminal, as described above, the system configuration wizard
automatically runs to guide the user through the entire setup process. The wizard prompts for all
necessary parameters, displaying default values, where applicable. You may accept the default values or
define other values.
When the dialog is complete, you may review the new configuration before applying it. The system
displays the configuration, including parameters that were not changed. The system also displays any
errors that are detected in the configuration. When the configuration is satisfactory, you may apply and
save the new configuration.
The following table lists all the parameters included in the initial configuration. It is recommended that
you obtain values for any parameters that you will configure at this time before beginning the setup.
For further information regarding any configuration step or specific parameter, refer to the relevant
Note
section in the
Cisco SCE 1000 2xGBE Installation and Configuration Guide
5-4
Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
Initial System Configuration, page 5-4
Step 1: Configuring Initial Settings, page 5-7
Step 2: Configuring the Hostname, page 5-8
Step 3: Setting the Passwords, page 5-8
Step 4: Configuring Time Settings, page 5-10
Step 5: Configuring the DNS Settings, page 5-12
Step 6: Configuring the RDR Formatter Destination, page 5-13
Step 7: Configuring Access Control Lists (ACLs), page 5-13
Step 8: Configuring SNMP, page 5-17
Step 9: Configuring the Topology-Dependent Parameters, page 5-20
Step 10: Completing and Saving the Configuration, page 5-23
Setup Command, page 5-4
Setup Command Parameters, page 5-5
Example, page 5-7
Cisco SCE 2000 and SCE 1000 Software Configuration Guide.
OL-26790-01