How To Replace The Power Supply Unit - Cisco SCE 1000 Installation And Configuration Manual

How to Replace the Power Supply Unit

How to Replace the Power Supply Unit

Do not mix AC-input and DC-input power supply units in the same SCE 1000 platform.
Note
Grasp the power supply unit handle with one hand and place your other hand underneath the power
Step 1
supply for support.
Fit the groove in the side of the new power supply module into the guide in the chassis.
Step 2
Gently, but firmly, slide the module into the chassis until its faceplate is flush with the chassis rear panel.
Step 3
When inserting a power supply into the SCE 1000 platform, do not use unnecessary force; slamming the
Note
power supply into the chassis can damage the connectors on the rear of the power supply.
Seat the power supply in the SCE 1000 platform by tightening the captive installation screw with a
Step 4
1/4-inch flat-blade screwdriver.
The power supply is not fully seated until you tighten the installation screw on the faceplate.
Note
Cisco SCE 1000 2xGBE Installation and Configuration Guide
4-20
Chapter 4 Installation and Maintenance
OL-26790-01