Example; Step 2: Configuring The Hostname; Step 3: Setting The Passwords - Cisco SCE 1000 Installation And Configuration Manual

Step 2: Configuring the Hostname

Configure the subnet mask.
Step 2
The current subnet mask is displayed.
•
•
Configure the default gateway.
Step 3
The current IP address of the default gateway is displayed.
•
•

Example

The following example displays a typical configuration of the IP address (10.1.5.109), subnet mask
(255.255.0.0), and default gateway (10.1.1.3).
Since the IP address and the subnet mask are related, when the IP address is changed, there is no longer
a default value of the subnet mask, and it must be entered explicitly.
Enter IP address [10.1.1.201]:10.1.5.109
Enter IP subnet mask:255.255.0.0
Enter IP address of default gateway [10.1.1.3]:

Step 2: Configuring the Hostname

The hostname is used to identify the SCE 1000. It appears as part of the CLI prompt and is also returned
as the value of the MIB-II object sysName.
The maximum length is 20 characters.
The default hostname is SCE 1000.
Specify the hostname for the SCE platform.
Step 1
The default hostname is displayed.
•
•

Step 3: Setting the Passwords

Configure the passwords as follows:
•
•
Cisco SCE 1000 2xGBE Installation and Configuration Guide
5-8
Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
To accept the displayed value, press Enter.
To change the value, type the desired value in the format "x.x.x.x" and press Enter.
To accept the displayed value, press Enter.
To change the value, type the desired value in the format "x.x.x.x" and press Enter.
To accept the displayed value, press Enter.
To change the value, type any desired character string and press Enter.
Enter hostname [SCE 1000]:
Set the password for each authorization level (User, Admin, Root).
Enable/disable password encryption. When password encryption is enabled, it encrypts the
previously entered passwords.
OL-26790-01