Chapter 8 Troubleshooting; Introduction - Cisco SCE 1000 Installation And Configuration Manual

Troubleshooting
Revised: September 17, 2012, OL-26790-01

Introduction

Your SCE 1000 platform went through extensive testing before leaving the factory. However, if you
encounter problems starting it, use the information in this chapter to help isolate the cause of the
problems. The procedures in this chapter assume that you are troubleshooting the initial system startup,
and that your SCE 1000 platform is in the original factory configuration. If you have removed or replaced
components or changed any default settings, the recommendations in this chapter might not apply. Make
sure to review the safety warnings listed in the
Cisco Service Control Engines (SCE)
the troubleshooting procedures in this chapter.
•
•
OL-26790-01
Troubleshooting Overview, page 8-2
Troubleshooting with the User Log, page 8-14
C H A P T E R
Regulatory Compliance and Safety Information for the
document that accompanied your SCE 1000 platform before using
Cisco SCE 1000 2xGBE Installation and Configuration Guide
8
8-1