Power Supply Specifications - Cisco SCE 1000 Installation And Configuration Manual

Chapter 4 Installation and Maintenance
Table 4-5
LED State
On (green)
Off
Table 4-6
LED State
Continuous green
Red
Unlit
Simple Network Management Protocol (SNMP) monitors the activity of the power supplies. In most
Note
cases when a power supply problem occurs, an SNMP trap is sent in SNMP and the appropriate message
is posted on the SCE 1000 CLI.

Power Supply Specifications

Table 4-7
Table 4-7
Input
AC-input power
AC-input voltage rating
AC-input current rating
AC-input frequency rating
AC-input cable
DC-input power
DC-input voltage rating
DC-input current rating
OL-26790-01
OK LED Status for AC-input and DC-input Power Supply Units
Power LED (on front panel) Status for AC-input and DC-input Power Supply Units
lists the AC-input and DC-input power supply specifications for the SCE 1000 platform.
SCE 1000 Power Supply Specifications
Power Supply Unit Condition
The output voltage is in the required range
(between 11.9 and 12.1 VDC).
The output voltage is not within the required
range. (is greater than 12.1 VDC or less than 11.9
VDC)
Power Supply Unit Condition
Corresponding power supply unit is present and
functioning normally
Corresponding power supply unit present, but
malfunctioning
Corresponding power supply unit is either not
present or has failed.
Specification
200W maximum
100 to 240 VAC
Rated for 4.5A when Vin = 100 VAC or 2A when
Vin = 200 VAC
50 to 60 Hz
18 AWG three-wire cable, with a three-lead
IEC-320 receptacle on the power supply end, and
a country-dependent plug on the power source
end.
200W maximum
-48/-60 VDC nominal (-36 to-72 VDC supply
tolerance)
7A at -48 VDC
Cisco SCE 1000 2xGBE Installation and Configuration Guide
Information About the Power Supply
4-17