Cisco SCE 1000 Installation And Configuration Manual page 9

About this Guide
Revised: September 17, 2012, OL-26790-01
Introduction
This preface describes who should read the Cisco Service Control Engine 1000 2xGBE Installation and
Configuration Guide, how it is organized, and its document conventions.
This installation guide explains the initial hardware installation and basic configuration procedures for
the SCE 1000. It contains procedures for unpacking and installing the device and performing basic
configuration via the setup wizard. After completing the installation and basic configuration procedures
covered in this guide, you will then use the appropriate companion publications to more completely
configure your system.
This guide contains instructions on how to install and run the SCE 1000 platform. This guide assumes a
basic familiarity with telecommunications equipment and installation procedures. This introduction
provides information about the following topics:
•
•
•
•
•
•
Audience
This guide is for the networking or computer technician responsible for installing and configuring the
SCE 1000 platform on-site. To use this publication, you should be familiar with telecommunications
equipment and installation procedures, as well as electronic circuitry and wiring practices. You should
also have experience as an electronic or electromechanical technician.
OL-26790-01
Audience, page ix
Document Revision History, page x
Organization, page xi
Related Publications, page xii
Conventions, page xiii
Obtaining Documentation and Submitting a Service Request, page xiv
Cisco SCE 1000 2xGBE Installation and Configuration Guide
ix