Examples - Cisco SCE 1000 Installation And Configuration Manual

Step 9: Configuring the Topology-Dependent Parameters

Examples

The following examples present the procedure for configuring the topology-related parameters for
various topologies. Refer to Information About Topology for a summary of appropriate values for the
parameters for each topology.
•
•
•
Example 1:
Following is a sample topology configuration for a topology using an external switch.
•
•
Would you like to enter the Topology configuration menu? [no]: y
Enter Connection mode:
1- inline
2- receive-only
Enter your choice [1]: 2
Data collection for the system configuration is completed.
All other parameter values are automatically assigned by the system.
Example 2:
Following is a sample topology configuration for a non-redundant bump-in-the-wire (inline) topology.
All values are the system default values, so it is not necessary to type in the response. Simply press enter
at each line.
•
•
•
•
Would you like to enter the Topology configuration menu? [no]: y
Enter Connection mode:
1- inline
2- receive-only
Enter your choice [1]:
Enter On-failure behavior:
1- Bypass
2- Cutoff
Enter your choice [1]:
Enter admin status of the SCe after abnormal boot:
1- Operational
2- Not-Operational
Enter your choice [1]:
Data collection for the system configuration is completed.
Cisco SCE 1000 2xGBE Installation and Configuration Guide
5-22
Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
Example 1:, page 5-22
Example 2:, page 5-22
Example 3:, page 5-23
Link bypass mode on-failure — Bypass
Admin status of the SCE after abnormal boot — Operational
Connection mode—Inline
For a non-redundant topology, link bypass on-failure should be Bypass, so that traffic continues to
flow through the link.
After operation of the system resumes, and the SCE 1000 reboots, the SCE 1000 will resume
operation. (Admin status after abnormal reboot is Operational.)
OL-26790-01