How To Set Up The Local Console - Cisco SCE 1000 Installation And Configuration Manual

How to Set Up the Local Console

How to Set Up the Local Console
Even if you will be managing the SCE 1000 from a remote location, you must first connect the unit to a
local console and configure the initial settings for the SCE 1000 to support remote management. When
the initial connection is established, the setup utility will run automatically, prompting you to perform
the initial system configuration
This section provides instructions for setting up your local terminal at your workstation, to enable you
to perform the initial system configuration of the SCE 1000 system using the setup utility.
Figure 5-1
1
Make sure that the terminal configuration is as follows:
•
•
•
•
•
The above SCE 1000 port parameters are fixed and are not configurable.
Plug the <SKIP> serial cable provided with the SCE 1000 into the CON port on the front panel of the
Step 1
SCE 1000.
Make sure that you push on the RJ-45 connector (attached to the <SKIP> serial cable) until you hear a
"click", which indicates that the connector is fully inserted and secured in the receptacle. Gently pull on
the plug to confirm whether the plug is locked into the socket.
Step 2 Connect the other end of the serial cable (with an attached DB-9 connector) to the VT100 compatible
local (serial) terminal.
Make sure the local terminal is configured as a VT-100 terminal, according to the fixed SCE 1000 CON
Step 3
port parameters.
Press Enter several times until the Cisco logo appears on the local terminal and the setup configuration
Step 4
Cisco SCE 1000 2xGBE Installation and Configuration Guide
5-2
Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
Connecting the Local Console to the SCE 1000 CON Port
PW R A
PW R B
STA TU S
MN G 1
MN G 2
CO NS OL
E
AU X
LIN K/
10/1 00/
ACT IVE
LIN K/
100 0 10/1 00/
ACT IVE
100 0
3
2
9600 baud
8 data bits
No Parity
1 stop bits
No flow control
(Figure 5-1).
BY PAS S
C is co S
C E 1 0 0 0
Se rie s
LIN K RX
2 xG B E
TX
LIN K RX
TX
RX
MM
TX
RX
MM
TX
GB E-1
SU B
LIN E
NE T
OL-26790-01