Troubleshooting The Management Subsystem - Cisco SCE 1000 Installation And Configuration Manual

Chapter 8 Troubleshooting
Table 8-5
Diagnostic Action
Returned error is:
Package file <filename>does
not contain magic header
Returned error is:
Error-There are only X free
bytes on device <device
name>, but Y bytes are
needed for the extraction
(where X and Y are stated in
bytes)

Troubleshooting the Management Subsystem

Check the following to help isolate a problem in the management subsystem.
Problems in the management subsystem could be any of the following:
•
•
•
•
•
Note When the management link is down and/or a Telnet connection cannot be established, you must open a
CLI session on a local terminal connected to the CON port. This enables you to solve the problem and
then reconnect through the management port.
OL-26790-01
Troubleshooting the Firmware Package Installation (continued)
Management link is down. (Mng LINK LED not lit--also Status is WARNING)
Management link is up (Mng LINK LED lit) but does not answer ping
Telnet connection cannot be established due to link problems (Mng LINK LED not lit)
Management link is up (Mng LINK LED lit) but Telnet connection cannot be established
Telnet connection established, but terminates automatically
The file is not a software
installation package file.
/tffs0/ device is full.
Cisco SCE 1000 2xGBE Installation and Configuration Guide
Problem Solving Using a Subsystems Approach
Verify that you are trying to open
the
/////////////////////////////////////////////
/////////////////////////////////////////////
/////////////////////////////////////////////
/////////////////////////////////////////////
////////////////.................................
..................................................
...........correct package file.
Delete old and unnecessary files
and try the package extraction
again.
8-9