Cisco SCE 1000 Installation And Configuration Manual page 42

Status of the SCE 1000 After Abnormal Boot
Table 3-1
Description
Link connection via
external switch with
port-mirroring
Bump-in-the-wire
Bump-in-the-wire,
monitor and control, not
redundant
Bump-in-the-wire,
monitor only, not
redundant
Bump-in-the-wire,
monitor and control,
redundant
Bump-in-the-wire,
monitor only, redundant
1. Italicized values represent automatically applied defaults that are applied based on previously defined parameters. These
values can be changed only via specific CLI commands.
2. In a redundant topology, it is also possible to configure admin status after abnormal boot to be Not operational. In this case,
though, the SCE 1000 would have to be manually reloaded to resume full functionality.
Cisco SCE 1000 2xGBE Installation and Configuration Guide
3-12
Topology Configuration Summary
Connection mode
Receive-only
Inline
Inline
Inline
Inline
Chapter 3 Information About Topology
On-failure link bypass Admin status after
mode abnormal boot
1
Bypass Operational
Bypass Operational
Bypass Operational
Cutoff Operational
Cutoff Operational
2
OL-26790-01