Checking The Leds - Cisco SCE 1000 Installation And Configuration Manual

Information About Troubleshooting Tools
•
Refer
user log.

Checking the LEDs

The front panel LEDS are the most immediate problem-detection mechanism of the platform. Refer to
the following sections for information on SCE 1000 platform LEDS:
•
•
Cisco SCE 1000 2xGBE Installation and Configuration Guide
8-4
Following is a sample output from the show line vty timeout command.
Timeout is 30 minutes
Troubleshooting the link interface subsystem:
show interface Gigabit Ethernet 0/#—Displays information for a specific GBE Interface.
–
Following is a sample output from the show interface command.
ip address: 10.1.6.145
subnet mask: 255.255.0.0
Configured duplex: auto
AutoNegotiation is On, link is Up, actual duplex: half
– show interface Gigabit Ethernet 0/# counters—Displays the values of counters of a GBE
interface.
Following is a sample output from the show interface counters command.
In total octets: 191520
In good unicast packets: 560
In good multicast packets: 0
In good broadcast packets: 0
In packets discarded: 0
In packets with CRC/Alignment error: 0
In undersized packets: 0
In oversized packets: 0
Out total octets: 0
Out unicast packets: 0
Out non unicast packets: 0
Out packets discarded: 0
toTroubleshooting with the User Log, page 8-14
Front Panel
SCE 1000 Operational Status
Chapter 8 Troubleshooting
for an explanation of commands related to the
OL-26790-01