Example; Step 1: Configuring Initial Settings - Cisco SCE 1000 Installation And Configuration Manual

Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
Following are some general instructions regarding the setup dialog:
•
•
•
•
•
•

Example

Would you like to enter the SNMP configuration menu? n
To abort the setup dialog at any point without making any configuration changes, press ^c . All changes
already entered will be lost, with the exception of time settings.

Step 1: Configuring Initial Settings

Verify the following initial settings for the SCE 1000:
•
•
•
All values are Internet addresses of the form 'X.X.X.X', where each letter corresponds to a decimal
number between 0 and 255.
Configure the IP address.
Step 1
The current IP address is displayed.
•
•
OL-26790-01
All default values appear in square brackets [default].
If no value appears in the brackets [], or more than one option appears [yes/no], then this parameter
does not have a default value.
To accept the default value, press Enter.
If you need more information about any parameter, type ? and press Enter.
A help message will appear describing the expected format of the parameter and any other
requirements.
To jump to the end of the setup dialog at any point, accepting all remaining default values, press ^z .
In certain cases, there will be two or more logically related parameters within a menu. In these
situations, it is not permitted to jump to the end of the setup dialog until all related parameters are
configured. If you try to jump to the end of the setup dialog, the following message will appear:
"Sorry, Skipping is not allowed at this stage."
Certain groups of related parameters, such as time, date, and SNTP settings, form sub-dialogs or
menus within the setup dialog. You may skip an entire menu, thereby accepting all default values
for the parameters within the menu.
Each group of related parameters is prefaced by a question, asking whether you want to enter the
menu. To skip the menu, answer no ("n") to the question.
IP address
Subnet mask
Default gateway
To accept the displayed value, press Enter.
To change the value, type the desired value in the format "x.x.x.x" and press Enter.
Cisco SCE 1000 2xGBE Installation and Configuration Guide

Step 1: Configuring Initial Settings

5-7