136: Indent Ribbon Break; 137: Embosser Wheel Error; 138: Embosser Indent Error; 139: Lost Card, Open Emboss Cover - Entrust Datacard CR825 User Manual

136: Indent ribbon break

The embosser indent ribbon is not moving properly.
1.
Open the embosser and remove the indent ribbon cartridge.
2.
Reposition, repair, or replace the ribbon and advance the repaired area one full turn.
3.
Replace the cartridge, and then close and lock the embosser.
H & T
INTS IPS
Refer to "Load the Indent Ribbon Cartridge"
Topping Foil" on

137: Embosser wheel error

The card path is blocked in the embosser.
1.
Open the embosser and remove the supply cartridges.
2.
Remove any cards found.
3.
Replace the cartridges, and then close and lock the embosser.

138: Embosser indent error

The embosser indent ribbon is not moving properly.
1.
Open the embosser and remove the indent ribbon cartridge.
2.
Reposition, repair, or replace the ribbon and advance the repaired area one full turn.
3.
Replace the cartridge, and then close and lock the embosser.

139: Lost card, open emboss cover

The card is not correctly positioned in the embosser.
1.
Open the embosser and remove the supply cartridges.
2.
Remove any cards found.
3.
Replace the cartridges, and then close and lock the embosser.

140: Embosser not available

The printer and embosser cannot communicate. The card will be canceled.
1.
Make sure the data cable from the embosser to the printer is securely plugged in.
2.
Press the printer P
3.
Press the P
CR825 and CE875 Instant Issuance System User's Guide
page A-11 for more information.
button to power off the printer and embosser.
OWER
button again to power on the printer and embosser.
OWER
on page A-6 or to "Repair Broken Indent Ribbon or
87