131: Embosser Card Exit Jam; 132: Embosser Card Stack Full; 133: Embosser Card Reject Full; 135: Indent Ribbon Supplies Out - Entrust Datacard CR825 User Manual

131: Embosser card exit jam

The card path is blocked in the embosser.
1.
Open the embosser and remove the supply cartridges.
2.
Remove any cards found.
3.
Replace the cartridges, and then close and lock the embosser.
H & T
INTS IPS
Refer to "Clear an Embosser Card Jam"

132: Embosser card stack full

The embosser output hopper is full or blocked.
Remove cards from the output hopper.

133: Embosser card reject full

The embosser reject tray is full.
1.
Open the embosser and empty the reject tray.
2.
Close and lock the embosser.
H & T
INTS IPS
The embosser reject tray holds five cards. Empty it regularly to avoid receiving the message.
Refer to "Empty the Embosser Reject Tray"

135: Indent ribbon supplies out

The embosser does not have usable indent ribbon.
1.
Open the embosser and remove the indent ribbon cartridge.
2.
Install a new indent ribbon.
3.
Replace the cartridge, and then close and lock the embosser.
H & T
INTS IPS
Refer to "Load the Indent Ribbon Cartridge"
86
on page A-10 for more information.
on page A-9 for more information.
on page A-6 for more information.
Troubleshooting