Hot-Swap Power Supply - Lenovo ThinkServer TS460 User Manual And Hardware Maintenance Manual

3. Slide the new drive into the drive bay until it snaps into position. Then, completely close the handle.
Figure 50. Installing the drive
4. Check the drive status LEDs to ensure that the drive is operating properly. You might have to restart the
server for the newly installed drive to be recognized. See "Hot-swap drive activity and status LEDs" on
page 24. If the drive is faulty, reinstall it until it is operating properly.
5. Close and lock the front door.

Hot-swap power supply

The hot-swap power supplies help you avoid significant interruption to the operation of the system when a
power supply fails. You can install or replace a power supply without turning off the server.
• "Removing a hot-swap power supply" on page 81
• "Installing a hot-swap power supply" on page 81
CAUTION:
Hazardous moving parts. Keep fingers and other body parts away.
CAUTION:
Never remove the cover on a power supply or any part that has the following label attached.
Hazardous voltage, current, and energy levels are present inside any component that has this label
attached. There are no serviceable parts inside these components. If you suspect a problem with one
of these parts, contact a service technician.
80
ThinkServer TS460 User Guide and Hardware Maintenance Manual